***FOR SALE***

THIS “FIRST EVER PRODUCED”

CD RACK/VIEWING SYSTEM

INCLUDING THE CASES

 

FOR OVER 10 YEARS I HAVE TRIED TO USE

THOSE CD RACKS MADE OF WIRE OR PLASTIC!

AND ALWAYS END UP FRUSTRATED WITH

LABELING AND THEN TRYING

TO READ THE LABELS.

DIGGING THE CASES OUT OF THE SLOTS, etc.

NOW THE FRUSTRATION IS OVER!

 

I HAVE INVENTED, AND BUILT THIS FIRST MODEL PROTOTYPE FOR SALE,

 AND APPLIED FOR A

U.S. Patent (Patent Pending # 11163136)

THIS CD RACK IS TOO HOT FOR TODAY'S MARKET TO WAIT 2 YEARS FOR THE

U.S. PATENT OFFICE TO REVIEW!

 

This holder has been temporarily mounted on a piece of Oak plywood for demonstration.

This holder can be mounted under a computer hutch,           

(top mount)

or on a wall over your entertainment center for music, and DVD disks.

    (rear mount)

With this CD RACK/VIEWING system you can

Easily flip to view 25 CD’s full face labels.

 

When you spot the one you want,

Simply slide the case to the middle of the rods,

A slight pressure from the spring loaded latches allows you to lift the case up,

And out of the holder,

When you are returning the CD case to the holder,

You start from the bottom, below the rods.

Place the case against the rear wall of the holder,

Lift at the middle of the rods

Until the latches pull themselves into the case holes

Then down and your case is back on the rods,

and ready for next time.

 

I MIGHT BE WILLING TO SELL THE

PATENT PENDING FOR $250,000.00

PLUS 1% ROYALTIES OF GROSS SALES OF ALL CD RACKING SYSTEMS USING MY DESIGN.

THIS DESIGN BEING THE

“ROD AND SPRING LATCH TYPE”

SHOWN HERE.

MY ENGINEERS HAVE STATED THAT THIS DESIGN

CAN BE INCREASED IN LENGTH, TO HOLD UP TO 100 CD's

 

FOR PATENT SALE INFORMATION

MY EMAIL ADDRESS IS: gkuhns@seegullinc.com

 

 

 

Hit Counter